PC3400 Series Coating Drying Application Systems

The PC3400 series flux application systems are designed to support the HAL5124 Hot Air Solder Leveling system by applying flux to circuit boards prior to the HASL process. The PC3400 employs a set of nappy type rollers to provide complete flux coverage. The first roller applies flux to the entire board surface. The second roller forces flux into the barrels providing complete surface coverage. Excess flux is filtered and recycled proving a significant cost savings.

The PC3400 includes a preheat stage which allows the panel to enter the HASL system warm, this reduces the heat loading in the solder pot and can make some fluxes more active. Preheating of high-mass circuit boards enables increased HASL production by minimizing solder pot dwell times. 

Electrical Service Requirements

Circuit Breaker service is 2-phase configuration with a good Ground.

 Shipping Data

Note: Crating dimensions and weights are approximate and may vary within 10%.

PC3420 Physical Dimensions

PC3430 Physical Dimensions

Home | Products | Distributors | Topics | LPISM FAQ | About Us | Contact Us | Terms of Use | Site Map

Solar Photovoltaic Thin Film | Liquid Photo-Imageable Solder Mask | Hot Air Leveling | Fusing | UV Processing

Copyright © 1997-2010 Argus International, Inc.  All rights reserved.