HL2400 Series Postcleaning Systems

The HL2400 series postcleaing systems were designed to follow the Argus HAL5100 series Hot Air Solder Leveling system. The machine is designed to provide a flux removal with vigorous spray cleaning, mild brushing action, fresh water rinse and turbo air drying. Board cleanliness is critical to quality PCB fabrication.

The HL2400 series postcleaning systems provide a cooling zone that allows the molten solder to solidify prior to active cleaning. The PCB is then exposed to a recirculated spray cleaning a mild brushing action that removes the surface flux residue left over from the HASL process. The second recirculation chamber provides a second recirculation of cleaner spray and mild brushing action and a final clean water rinse. The drying system may have a turbo air knife to remove any puddled water and an infrared drying section to complete the drying process. A variety of brushing and drying options are available to maximize the effectiveness of the postcleaning system.

Available Options

Postcleaner Injection System: Provides the ability to inject postcleaning chemistry directly into the recirculating spray manifold. Postcleaning solutions can significantly improve the effectiveness of the HL2400.

Antifoam Injection System: Provides the ability to inject antifoam solution into the HL2400 drain. The antifoam solution normally is used when either the flux or the postcleaning solution generates large amounts of foam.

Turbo Air Knife Drying: Adds an increased drying capability by employing high velocity air to remove puddled water on exit from the HL2400. This option makes the IR drying more effective by reducing drying requirements.

24 Inch Exit Extension: Extends the exit conveyor 24" to allow for inspection or mating with other handling equipment.

Remote Control Console: Moves all controls away from the machine allowing the operator to make convenient adjustments.

Recirculating Sump Heating: Provides a sump heating system. Flux residues are more easily removed with modest increases in spray temperature.

Electrical Service Requirements

Circuit Breaker service is 3-phase configuration with a good Ground.

Item

200-240V 50/60Hz

380-415V 50Hz

440-480V 50/60Hz

Power

HL2420 Circuit Breaker

100A

50A

50A

17kVA

HL2430 Circuit Breaker

150A

70A

70A

25kVA

Fresh Water Rinse Requirements

Item

Volume

Connection Fittings

HL2420

2 Gallons per minute

3/4"NPT Service, Cold/Hot Mixer Valve included

HL2430

Drainage Requirements

Rinse Drain

Item

Volume

Connection Fittings

HL2420

2 Gallons per minute

1 1/2"NPT, PVC

HL2430

Shipping Data

Item

Crate Size

Crated Weight

Air Freight

Common Carrier

HL2420

123" x 63" x 72"

1,400 lbs.

1,900 lbs.

HL2430

123" x 63" x 72"

1,500 lbs.

2,000 lbs.

Note: Crating dimensions and weights are approximate and may vary within 10%.

HL2420 Physical Dimensions

 

HL2430 Physical Dimensions

HL2400 Double Postcleaner Dryers


Printer Formatted Document


Home | Products | Distributors | Topics | LPISM FAQ | About Us | Contact Us | Terms of Use | Site Map

Solar Photovoltaic Thin Film | Liquid Photo-Imageable Solder Mask | Hot Air Leveling | Fusing | UV Processing


Copyright © 1997-2012 Argus International, Inc.  All rights reserved.